Amateur Radio Service Operator License - General Class Exam Prep
Free practice questions

Free FCC-AMATEUR-GENERAL Practice Questions

10 exam-style questions with answers and explanations, straight from our 1,030-question bank. Tap an answer to check yourself. When you're ready, take the scored version in the free practice test.

Start the free practice test → ★★★★★4.9/5 from 2,400+ candidates · No signup

These 10 free FCC-AMATEUR-GENERAL questions are organized by exam domain, so you can see how each part of the Amateur Radio Service Operator License - General Class blueprint is tested. Reveal the answer and explanation under each question.

Domain 1: Commission's Rules

Question 1

Yesterday, a current Technician licensee passed Element 3, received a CSCE, and properly submitted the upgrade application to the examining VEs. The FCC database still shows Technician. May this operator now make an SSB contact on 14.250 MHz from a station in the United States?

Show answer & explanation

Correct answer: C - Yes, using the existing call sign followed by 'slash AG.'

Question 2

At a station in the continental United States, a General licensee plans an ordinary amateur contact on a clear frequency of 10.140 MHz. Which proposed transmission complies with both the authorized emission types and the transmitter power ceiling for this band?

Show answer & explanation

Correct answer: A - 150 W PEP using RTTY

Domain 2: Operating Procedures

Question 3

A CW signal is moderately strong and has a perfectly pure tone, but atmospheric crashes make it readable only with considerable difficulty. Which RST report accurately describes this reception?

Show answer & explanation

Correct answer: D - 379

Question 4

On 40-meter FT8, numerous strong signals are visible within the receiver's USB passband, and the audio level is within the software's recommended range. None decode. Their transmissions consistently begin about eight seconds away from the software's 15-second period boundaries. What should be corrected first?

Show answer & explanation

Correct answer: D - Synchronize the computer clock to an accurate UTC source.

Domain 3: Radio Wave Propagation

Question 5

An HF emergency net must reach communities 80 to 200 miles away behind mountain ranges. The F-layer vertical critical frequency is 5.6 MHz, and absorption on 75 meters is low. Which arrangement best supports the needed regional coverage?

Show answer & explanation

Correct answer: B - A horizontal 75-meter dipole, mounted about 0.15 wavelength above ground.

Domain 4: Amateur Radio Practices

Question 6

Several signals appear across an HF receiver's tuning range whenever a very strong station transmits. Inserting the receiver's input attenuator makes those signals disappear and improves reception of a weak station. This behavior most strongly indicates:

Show answer & explanation

Correct answer: A - Intermodulation generated by nonlinear operation of the receiver's overloaded front end.

Domain 5: Electrical Principles

Question 7

A 100-W SSB transmitter is tested into a 50-ohm resistive dummy load. During speech, an average-reading RF wattmeter shows about 25 W. At the envelope crest, an accurately scaled oscilloscope trace across that load shows 200 V peak-to-peak of sinusoidal RF without clipping. How should these readings be interpreted?

Show answer & explanation

Correct answer: D - The 100-W PEP output is consistent with a 25-W average speech reading.

Domain 6: Circuit Components

Question 8

Which diode is designed to act as a voltage-controlled capacitor when reverse-biased in an RF tuning circuit?

Show answer & explanation

Correct answer: C - A varactor diode

Domain 9: Antennas and Feed Lines

Question 9

An external tuner beside the transceiver brings its indicated SWR down to 1.1:1. The nonresonant antenna and the coax between the tuner and antenna are unchanged, and all components are operating within their ratings. What is the sound assessment of this setup?

Show answer & explanation

Correct answer: B - The radio sees a good match; the antenna-side mismatch remains.

Domain 10: Electrical and RF Safety

Question 10

Before servicing a tube amplifier, a qualified operator unplugs it and opens the cover interlock. A bleeder resistor is installed across the high-voltage filter capacitors. Which additional step is essential before touching the high-voltage circuitry?

Show answer & explanation

Correct answer: C - Discharge stored energy with rated equipment and verify the absence of voltage.

The rest of the FCC-AMATEUR-GENERAL blueprint

The FCC-AMATEUR-GENERAL exam also covers these domains. Drill them in the full free practice test:

That's 10 of 1,030

The full bank has 1,020 more FCC-AMATEUR-GENERAL questions with explanations.

Continue in the free practice test →

View plans